Z644Tc-10Q double-disc air-lock wear-resistant ceramic equalizer valve

Z644Tc-10Q double-disc air-lock wear-resistant ceramic equalizer valve (Warning: The products are proprietary and patented, and unauthorized reproduction will be prosecuted锛孭atent No锛歓L03278197.0) (Our company has passed ISO9001锛�2000.)
銆�銆�The valves are mainly used for opening and closing of charging and discharging of gas and slag in dry ash system of power plant, and also applicable for opening and closing of such media as wear and corrosion-resistant fine dust, water, oil and vapor at tube edge in the industries of mining, paper-making and petrochemical etc. PG double-disc air-lock wear-resistant ceramic valve has the advantages of good sealing property, high temperature resistance, strong wearability, easy starting, no ash deposit and long service life. The body of KR double-disc air-lock wear-resistant ceramic valve is combined with cast steel, cast iron and wear-resistant ceramics. Service temperature 鈮�250鈩� The nominal pressure of actuator is 0.4锝�0.6Mpa and the nominal pressure of valve is 1Mpa customizable according to user鈥檚 requirements
銆�銆�Installation instructions to bleeder valve锛� 銆�銆� Welcome to select the patented products of our company. In order to prolong service life and improve operating efficiency, this valve should be installed as vertical as possible, and if the conditions do not allow the installation should be carried out in 45掳. For upside-down or horizontal installation, the idle conveying time must be extended so as to avoid ash accumulation in valve. In this valve the return signal adopts imported inductive magnetic switch two-wire system, and the signal line can adapt to both DC and AC via load. 鈥淩efer to the figure for installation of signal line鈥� 銆�銆�Operating instructions 銆�銆� 1銆丅efore installation this instruction should be carefully read, and type, full bore and technical parameters of the valve be checked. 銆�銆� 2銆丄fter installation of valve welding flange is forbidden to prevent from damaging the seal ring of valve. The installation distance for valve reserved in pipelines shall be appropriate, and gaskets shall be added on both sides of flange. 銆�銆� 3銆乀he centers of two pipelines shall be remained coaxial with the center of valve full bore, and two sides of flange shall be smooth so as to guarantee clamping and normal operation of valve.